[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [T3] 009 timing measurement

To: <type3@vwtype3.org>
Subject: Re: [T3] 009 timing measurement
From: "Dave Hall" <dave@hallvw.clara.co.uk>
Date: Wed, 9 Nov 2005 20:47:59 -0000
List-help: <mailto:type3-request@vwtype3.org?subject=help>
List-post: <mailto:type3@vwtype3.org>
List-subscribe: <mailto:type3-request@vwtype3.org?subject=subscribe>
List-unsubscribe: <mailto:type3-request@vwtype3.org?subject=unsubscribe>
Old-return-path: <dave@hallvw.clara.co.uk>
References: <4371BA62.7080301@sun.com>
Reply-to: type3@vwtype3.org
Resent-date: Wed, 9 Nov 2005 13:19:17 -0800 (PST)
Resent-from: type3@vwtype3.org
Resent-message-id: <tZUc0C.A.u0I.VfmcDB@cedant5.abac.com>
Resent-sender: type3-request@vwtype3.org

> This is measured round the max circumference of a T3 pulley starting at the
centre of the TDC notch, which on my original '64 pulley is a smooth curved
notch.  The other timing marks on my '64 pulley are 3 'T shaped' grooves cast in
it just over half an inch to the right.  The left hand one is 7.5 degrees, the
second is 10 degrees and the third is 12.5 degrees.
>

If you just go 3 times the distance from TDC to 10 degrees BTDC, you get 30
degrees BTDC.  Mark this and never set the timing more than that!

Dave.
UK VW Type 3 & 4 Club
http://www.hallvw.clara.co.uk/
------

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

References:
- [T3] 009 timing measurement
  - From: Chris Wright <Christopher.Wright@Sun.COM>

Prev by Date: [T3] 32-phn choke troubles
Next by Date: Re: [T3] 32-phn choke troubles
Previous by thread: Re: [T3] 009 timing measurement
Next by thread: Re: Re: [T3] 009 timing measurement
Index(es):
- Date
- Thread