[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On Wed, 2005-04-13 at 22:28, John Jaranson wrote: > > Here is a picture of the nosecone and shift shaft. > > http://mywebpages.comcast.net/jaransonT3/TransSeal.jpg > > Am I missing the bushing and seal? I think so. Were there some > swingaxle transmission that didn't get one? > > I see them listed on CIPs site and other places. I hope my FLVWAPS has > them in stock so I can get my girl back on the road sooner rather than > later. Assuming of course that I should have one. > I can't see up inside the housing, but all shift housings should have the seal. I wouldn't think it would shift right if the brass bushing was missing. There is also supposed to be a dust boot to seal where the trans housing goes into the tunnel. I have a couple used trannies here, but I am not sure if they have what you need. I won't be able to check them until sometime next week. -- Russ Wolfe '71 FB AT '66 FB MT '64 T34 (not running) '65 T1 (not running) '05 KIA Sorento SUV russw@classicvw.org http://www.classicvw.org ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~