[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]

Re: [T3] Exhaust/Heat exchange hoses


On 11 May 99, at 10:54, oofacts@earthlink.net wrote:

> I need a new muffler. I have this GT tip muffler and its just ridiculous,
> to me. I'm looking for something a little more understated and quiet and I
> dont have the opportunity to go to swap meets. Any recommendations?

Do you still have the little rear heat exchangers? If so, consider 
going back to the OEM mufflers.

> And I have these heat exchange hoses and they keep crisping on me. What up
> with these things?I thought they were supposed to withstand heat. I got em
> from Bill and Steves, and they said yes these are T3 hoses (the silver
> accordion type duct ones) and I was just thankful they actually FIT but
> after 3 months they're all fried. Cracked right at the hose clamp.

Not sure how you can fry a steel hose? Are all your input connections 
in place so that you a‰ß$Ÿng enough air into the heat exchangers 
to keep them at a reasonable temp?

If you have a "performance" exhaust that omits the rear heat 
exchangers, then you may have lost the cheap hoses that carry the air 
from the fan housing to the lower heat exchangers. This would let 
them get very hot and might explain your problem. Of course if you 
don't have any incoming air, there is no point in worrying about the 
output hoses.

Jim
-
*******************************
Jim Adney, jadney@vwtype3.org
Madison, Wisconsin, USA
*******************************

-------------------------------------------------------------------
Search old messages on the Web!  Visit http://www.vwtype3.org/list/


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]