[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 23 May 2005 at 22:10, David Sanderson wrote: > My next question concerns the connections to the heat exchangers. On > the original '65 there were two arms - these are consistent with the > description in my Bentley, one side for heat and for the rear seats. > However, on the new pan, which is supposed to be a '68 vintage > Automatic pan, there are 5 tubes for wires. One pair of tubes exits > by the heat exchangers and I assume controls them, One pair controls > the small flaps in the rear under the seats, and there is another > that tube also dumps into under the right rear seat but I cannot see > what it attaches to. I had no idea what you meant until I read Bob's reply. You must be looking at the underside of the pan and he's probably right about this tube. The front end of that tube exits under the gas tank all the way to the front of the car. There are just 4 heater control wires and tubes: 2 exit outside, at either side of the nose of the tranny and 2 exit under the back seat, inside the car. -- Jim Adney jadney@vwtype3.org Madison, WI 53711-3054 USA ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~