[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 17 Mar 2005 at 18:50, Mysterious J wrote: > 1. Is the weld along the bottom of the panel (where it attaches to the > lower section of the ductwork) a series of spot welds or one long, > continuous weld? I think they are all a series of spot welds. From underneath you should be able to see the dimples. > 2. This panel does not have the holes for the license plate bracket. > Does someone have the measurements of where to install the captured nuts > for the bracket? Doesn't the fasty carry the plate on the lid? Sorry, I just don't deal with that many fastys. At any rate, I'll bet that it uses the same plate bracket rather than captured nuts. -- ******************************* Jim Adney, jadney@vwtype3.org Madison, Wisconsin, USA ******************************* ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~