Re: [T3] Figuring out the pulley degree notches.

[Michael Cecil <macecil@comcast.net>]

<x-flowed>At 11:21 AM 6/23/2005, Toby Erkson said:
>But how can you check it when you don't even know what notch represents
>0¼? ;-)  That is a nice wheel, BTW.  Thanks for the link :-)

Welcome.  I've just been using the 0 degree mark 
on my pulley assuming it's right, but there was a 
thread in RAMVA not long ago detailing this same 
problem.  I think it involved making a jig to go 
into a spark plug hole where you'd rotate the 
engine each way until the cylinder was stopped by 
the jig, marking each stop point on the pulley, 
then measuring halfway between 
them.  Hmmmm.  Here's the thread: http://tinyurl.com/cte5o

--
Michael Cecil
macecil@comcast.net
http://home.comcast.net/~macecil/


~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

</x-flowed>