[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 5 Jun 2005 at 22:14, Brad Mularcik wrote: > You were right, it was VERY obvious where I needed to remove metal. > There were very deep grooves cut into the housing on the "high spots". I > shaved them down with the die grinder and a burr bit. It went very well. > That is until it went really bad. And we are VERY sorry that we didn't think to warn you about this hazard, and grateful that it didn't turn tragic. -- ******************************* Jim Adney, jadney@vwtype3.org Madison, Wisconsin, USA ******************************* ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~