[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On Thu, 2005-07-21 at 21:19, BOB2TYPE3S@aol.com wrote: > > Have you removed the bolt? If not, you need to. If you have, then you need a > scrifical screw driver to drive into the slot, so you can spread it out. Once > this happens, the ball joint stud should literally fall out. I do it > differently, as I live in the rust belt. I normally remove the big 30mm nut on the > other end of the ball joint, as this is less likely to snap than the little 10mm > bolt. > Bob, I don't sacrifice a screw driver. I use a small cold chisel and drive it in the slot. -- Russ Wolfe '71 FB AT '66 FB MT '64 T34 (not running) '65 T1 (not running) '05 KIA Sorento SUV russw@classicvw.org http://www.classicvw.org ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~