[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
Aaron wrote:
> I just packed some grease in
>there for now, as suggested by Jim, and I'll plan to
>take the whole thing apart on both sides over the
>winter. Makes good sense to know it's done right. The
>driver's side had virtually no grease in there at all.
This should hold you until it starts salting. But most importantly, get that
axle nut tight. I got a car that had one back off, and it ate both the inner
and outer bearing within a couple hundred miles. Not good!! I had to field
replace it (bring all the parts with me to replace it) before I could move the
car, as it was that bad. I think the original seals here were blue, so the red
one was replaced.
Bob 65 Notch S w/ Sunroof
69 Squareback-AT - the baby suburban
71 Squareback- formerly undecided, now becoming a 2 seat Roadster, in
progress : ) getting closer
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org