[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [T3] rust repair panel

To: <type3@vwtype3.org>
Subject: RE: [T3] rust repair panel
From: "Joe Barnes" <joebarnes84@hotmail.com>
Date: Fri, 7 Mar 2003 13:45:38 -0000
Importance: Normal
In-reply-to: <OF42CDD18C.04BDE438-ON85256CE2.0048D65A@itwfeg.com>
List-help: <mailto:type3-request@vwtype3.org?subject=help>
List-post: <mailto:type3@vwtype3.org>
List-subscribe: <mailto:type3-request@vwtype3.org?subject=subscribe>
List-unsubscribe: <mailto:type3-request@vwtype3.org?subject=unsubscribe>
Old-return-path: <joebarnes84@hotmail.com>
Resent-date: Fri, 7 Mar 2003 05:45:51 -0800 (PST)
Resent-from: type3@vwtype3.org
Resent-message-id: <w4HA8D.A.S7G.PKKa-@cedant5>
Resent-sender: type3-request@vwtype3.org

As far as I'm aware, this is not available. The usual option is
fabrication or cutting a section from a car where this bit is ok.
Shouldn't be too hard to fabricate a section to fit the contours of
where you are talking about.

Joe

>I am looking to buy a repair panel for my 72 Squareback. It is under
the 
>front fenders near the doors at the top. there was a small box peice 
>welded there that held water which rusted out in to the trunk area and 
>into the interior area behind the fender. I also need a good rust free 
>front drivers side fender. Any help would be great.
>thanks
>Brian
>Brian McGilvery/Baxter/PMIFEG@PMI_FEG

-------------------------------------------------------------------
List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org

References:
- [T3] rust repair panel
  - From: Brian.McGilvery@baxtermfg.com

Prev by Date: RE: [T3] Window seal treatment
Next by Date: RE: [T3] rust repair panel
Previous by thread: [T3] rust repair panel
Next by thread: Re: [T3] rust repair panel
Index(es):
- Date
- Thread