[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
As far as I'm aware, this is not available. The usual option is fabrication or cutting a section from a car where this bit is ok. Shouldn't be too hard to fabricate a section to fit the contours of where you are talking about. Joe >I am looking to buy a repair panel for my 72 Squareback. It is under the >front fenders near the doors at the top. there was a small box peice >welded there that held water which rusted out in to the trunk area and >into the interior area behind the fender. I also need a good rust free >front drivers side fender. Any help would be great. >thanks >Brian >Brian McGilvery/Baxter/PMIFEG@PMI_FEG ------------------------------------------------------------------- List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org