[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
<x-charset windows-1255>Silly question; did you replace the brake fluid reservoir with a dual circuit one? Would that cause your problem if you haven't? Daniel > Here's the scenario: > > 62 Type 34 > > New parts: > M/C > rebuilt later(73) front calipers > new brake lines(front+rear), but not main line thru pan > new brake hoses(front+rear) > new wheel cylinders > > I've tried to bleed the system, but can't get pressure to the front > calipers. When I loosen the bleeder valves on the front calipers, fluid runs > out, but when I pump the pedal, nothing. The rear is bleeding out fine. I've > adjusted the push rod to the M/C, but the Bentley states it should not be > adjusted from the stock position. Have I installed a bad M/C? It was bench > bled. Any other early, single circuit guys out there have this problem when > converting to a dual circuit M/C? > > Help! > > Doug > > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org > > > </x-charset>