[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [T3] lower controling arm
On 30 Apr 2002, at 19:45, Russ wolfe wrote:
> That stud is replacable, but finding a new one might be hard, as they
> are "hard". Where they screw into the torsion arm, they are cross
> pinned. I looked in the Bentley, but they don't give any good pictures
> of it.
Is the inner end threaded? I've never seen or done this, but I thought the
description I read said to drill out the old stud and cross pin, ream the hole
for the replacement oversize stud, drill the cross hole and install the locking
pin.
>From this I just got the impression that it was a smooth shaft, threaded only
on the exposed end.
-
*******************************
Jim Adney, jadney@vwtype3.org
Madison, Wisconsin, USA
*******************************
-------------------------------------------------------------------
Unsubscribe? mailto:type3-request@vwtype3.org, Subject: unsubscribe