[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [T3] thermostat & air cooling flaps
On 9 Apr 2002, at 18:54, orntar@att.net wrote:
> is there a way to test the head sensor, mine ahs been spliced a few times
> and my engine is running rich consistently.
Just disconnect the lead and measure the resistance thru the sensor to
ground. You can do this cold and warm and compare the numbers you get to
those in the Bentley. The sensor is not likely the cause of your problem.
Check the charging system voltage. It should be above 14V with the engine
warmed up and at med rpm. If it is below 13.5V the FI will start to run rich. If
it is low, replace the voltage regulator.
-
*******************************
Jim Adney, jadney@vwtype3.org
Madison, Wisconsin, USA
*******************************
-------------------------------------------------------------------
Unsubscribe? mailto:type3-request@vwtype3.org, Subject: unsubscribe