Re: [T3] swing axle shaft

[rtvisser <rtvisser@xs4all.nl>]

>----- Forwarded Message -----
>From: "Jim Adney" <jadney@vwtype3.org>
>To: type3 <type3@vwtype3.org>
>Subject: RE: [T3] swing axle shaft
>
>On 1 Oct 2001, at 22:50, Richard Visser wrote:
>
>> One of my swing axle shafts is leaking oil. On close inspection it seams
>> its at the point where the damper mounting lug is attached to it. Maybe
>> because of it being welded on badly in the past.
>> Is it possible to remove the shaft without removing the transmission (and
>> engine)?
>
>It's probably possible, but I don't know if it is worth it. It might be
>better to seek out a good welder who could weld it back up with
>everyting in place.
>
>I don't remember how that assembly works. Is the damper bracket
>actually welded to the tube rather than being part of the outer end.
>assembly?

Yes, its welded on the shaft. Welding is a bit difficult because you can drain 
all the oil out but it's still greasy on the inside. Not ideal circumstances.
Anyone else with experience with the old set up?

-------------------------------------------------------------------
Unsubscribe? mailto:type3-request@vwtype3.org, Subject: unsubscribe