Re: [T3] Steering Wheel problem

["Dave Campen" <dave@campen.eurobell.co.uk>]

Use a small screwdriver or knife to pry out the centre badge from the wheel.
You should then be able to get your 27mm socket on the nut. If your socket
has very thick walls, you may need to remove the horn wire or even the horn
bar itself (3 small screws; don't lose the springs underneath the bar!) It's
not a bad idea to mark the centre of the wheel and the column so it goes
back in the same place.

-------------------------------------------------------------------
Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe