[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
> What I did was I got an M8 bolt in correct length, cut off the head and > milled it down to 6 mm by fastening it in the chuck on my powerdrill. Then > I used a new metal file, milled it down to 6 mm (@ 3000 rpm) and threaded > it to M6 threads. Before I threaded it, I cut it to proper length. What I do is go over to the bolt / stud drawer, in the far left of the shop, extract a M8/M6 step stud install it in the case and call it good. Greg -- Vintage Warehouse PO Box 2321 Windsor, Ca. 95492 USA http://vintagewarehouse.com 707.291.7606 Shop online without a credit card http://www.rocketcash.com RocketCash, a NetZero subsidiary ------------------------------------------------------------------- Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe