[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 29 Dec 2001, at 16:48, B. Mitchell wrote: > So I go out side a while ago to change the oil and adjust the valves > in the 71 square. I drain the oil and pop off the valve cover for 1&2 > and start to adjust #1. As I am loosening one of the nuts I notice > below it what looks like a large nut, Sure enough it is a head nut and > next to it is the washer. now a simple oil and valve adjust is gonna > have to become a head torque. Its to bad I cant drop the motor and do > it right . Start by just installing and torquing the 4 nuts under the valve cover. If that nut will take full torque then you're probably fine. If not, the stud is pulling out of the case and you're facing much more than a head retorque. NOTE: Head torque is different if your engine was built using 8mm studs. If you have these DON'T try to torque them to the 10mm torque! A rebuilt engine could come either way. - ******************************* Jim Adney, jadney@vwtype3.org Madison, Wisconsin, USA ******************************* ------------------------------------------------------------------- Unsubscribe? mailto:type3-request@vwtype3.org, Subject: unsubscribe