[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 28 Jun 99, at 19:04, aedan mcghie/scotland wrote: > On Mon, Jun 28, 1999 01:14, Jim Adney <mailto:jadney@vwtype3.org> wrote: > >I recommend that you use a simpler jack anywhere under the front axle > >beam or under either end of the rear torsion bar housing. Those > >places are made of heavy steel and are strong. > How about places to put axle stands? Would you put them in the same places? Yes, anywhere strong enough to jack from is also strong enough for jackstands. So.... Front: Anywhere on the bottom of the front axle beam including the 2 clamps at the ends. Rear: Torsion bar tubes and end plates. DON;'T go for the underside of the engine, as someone else already correctly pointed out. Jim - ******************************* Jim Adney, jadney@vwtype3.org Madison, Wisconsin, USA ******************************* ----------------------------------------------晌鄬------------- Unsubscribe? mailto:type3-request@vwtype3.org, Subject: unsubscribe