[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
Hey everyone. I've been working on my ' 70 Squareback trying to lower the rear end. When I was done adjusting spring plates I noticed that both sides are even without the fenders on (21 1/4 inches), but when I put the fenders back on and drove the car a short distance (out of the garage) I noticed that the two sides are not even anymore (one side is half an inch lower). What is going on???!!!!! I do admit that while doing one side I accidentally pulled the torsion bar out along with the spring plate. I put them back in the best I could but am concerned that this may have messed something up. Are the ends of the torsion bars different when it comes to number of splines? Did I rotate it a few splines out of whack? I have tried to readjust the higher side but it now is the lower side??!! Any ideas?? Thanks if you got any. Derrrick ' 70 Squareback ' 61 Ragtop