Re: [T3] Parting out front axle and rear subframe!

["Jim Adney" <jadney@vwtype3.org>]

On 7 Sep 2011 at 14:23, Cybernotchback wrote:

> You didn't specifically mention this but have you lowered the spring
> plate past the stop and relieved all of the tension off the bar(s)?Ê
> If not that will prevent you from pulling the spring plate off the
> bar.Ê Just too much force on the joint(s) to allow the bar to slip out
> of either end easily.Ê 

It's a catch 22: You have to pull it out maybe 2 cm before you can 
lower it back down below the stop. So breaking it loose must be done 
with all the tension still on it. Once it's lowered you're right: It 
should be easy then.

I've got good purchase with a good crowbar, but it just doesn't seem 
like it's enough. Maybe I'll see if a friend has a longer bar; mine 
is only about 2' long. I get the impression that all I need is about 
double the leverage, unless there's some other trick.


-- 
*******************************
Jim Adney, jadney@vwtype3.org
Madison, Wisconsin, USA
*******************************

_______________________________________________
VWType3.Org mailing list - type3@vwtype3.org
http://lists.vwtype3.org/listinfo.cgi/type3-vwtype3.org
Contact gregm@vwtype3.org if you need help with the list.