Re: [T3] Measuring fuel pressure -- hose size and fitting?

[Russ Wolfe <russw@classicvw.org>]

On Fri, 2005-05-20 at 21:13, Toby Erkson wrote:
> I bought a pressure gauge (0-60psi, +/- 3%/2%/3%) and gotta get the 
> right hose and fittings for it so I can check fuel pressure.  The 
> Bentley wasn't clear on how to attach the fuel pressure tester.  After 
> removing the cap (bolt?) does the gauge hose screw on to the fuel line 
> tap or does it require a hose clamp to keep the hose attached?  And what 
> size hose should I use?  Any additional info would be appreciated.  Thanks!
It needs a hose clamp. 
If you want to know the accuracy of the gage, send it to me and I can
check it against the "Bureau of Standards"
0-60 is a good choice for our use, as you will be operating in the
middle of its range. (the most accurate)

-- 
Russ Wolfe
'71 FB AT
'66 FB MT
'64 T34 (not running)
'65 T1 (not running)
'05 KIA Sorento SUV
russw@classicvw.org
http://www.classicvw.org

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~