[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 2 Jun 2005 at 13:48, Carrie wrote: > After a closer look at my front end and a look in my handy-dandy Bentley T3 > shop manual and found that no, I'm not missing any grease fittings. But it > does look like I'm missing a plug. There's a nice threaded opening in the > front of the bottom beam where I can see the stabilizer bar. Barring > actually finding the proper plug or using duct tape, what's the best way to > block this off?? Are you sure this is the FRONT of the BOTTOM beam? (Is the beam out of the car?) If this is the back of the upper beam, then there are 2 threaded holes there, M8 x 1.25. One anchors the steering damper and the other is for the steering damper on RHD cars and should have a plastic plug in it. Any of this sound right? -- Jim Adney jadney@vwtype3.org Madison, WI 53711-3054 USA ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~