[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On Thu, 2005-07-28 at 20:12, Keith Park wrote:
> Hi all,
>
> I need one of the weld on inserts... one of AT LEAST 1.05" ID I have one
> here that is a very loose fit and necks it down to .98" and thats just too
> much for me. Anyone have one of the ones thats a nice tight fit with a very
> thin guide sleeve?
>
> This one heaterbox is holding up getting the crate motor back togeather and
> everytime I order one I dont know what Im getting till it arrives a week
> later.
>
I went out to the shop, and found them. How many do you want?
http://classicvw.org/gallery/my_misc/dscf0073
Sorry about the poor picture. My camera skills were not the best.:+{
The ones in the front are the "store bought". The 2 in the rear are my
home made ones. The ID of the store bought is 1.022. Wall thickness of
the store bought where it goes into the heater box, is a little over
.055/ My home made ones are 0.996 ID with about the same wall thickness.
--
Russ Wolfe
'71 FB AT
'66 FB MT
'64 T34 (not running)
'65 T1 (not running)
'05 KIA Sorento SUV
russw@classicvw.org
http://www.classicvw.org
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~