Re: [T3] Distributor and breather box questions

[Toby Erkson <air_cooled_nut@pobox.com>]

<x-flowed>Correct.  A VW FLAPS should have the fitting with a threaded end so you 
simply put the fitting in the hole (threads will be on the inside) and 
place a rubber(?) washer under the nut that secures the fitting to the 
valve cover.

 Toby Erkson  --  http://www.icbm.org/
 '72 VW Squareback Darksider, 5-speed, 2.0L, rag top
 '72 VW Squareback Lightsider, automatic, FI, sunroof, gas heater
 '95 VW Jetta ~ SCCA Solo 2 EP #3; '73 Porsche 914; '81 Honda Gold Wing
 Portland, Oregon



Brad Mularcik wrote:

>    Did you just drill a hole in the valve cover for the fitting?  I 
> assume that fitting would be added somewhere relatively high on the 
> valve cover, and near the rear wher it is hard to see. 

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

</x-flowed>