[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
Hi, > Is this vacuum advance, mech advance or both? I believe is both based on previous research. > > Start by checking the advance mechanisms. You should be able to suck on the > vacuum advance cans and watch the points plate move and verify that the can > holds vacuum. To test the mech advance, just hold the bottom end of the shaft > while you twist the upper end CW. It should turn a bit and then run into a > hard > stop. It should snap back smartly when you release it. Everything should move > smoothly. I will run these tests as well. I knew I? Had to blow on the vacumm advance can but could not figure out what then :-} Thanks, -- Petri 71 Notch 02 Subaru Liberty RX (family wagon) ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~