[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On Sat, 2004-03-27 at 07:41, wfoh8x9 Martinez-Ortiz wrote: > Do I need to remove my brake cable from the Handle in front when removing > the Swing Axle Transmission assembly or is it simply easier to do. I was > reading the step by step swing axle removal procedure in the Hanes manual > and it stated to remove tha transaxle with the brake cables attached to the > drums. > I would think that by simply removing the drum center nut and then removing > the cables from the lever inside the drums... > If you are putting the same transaxle back, you can pull the drums and center flanges, and remove the backing plate, leaving the cable connected and with the car. Otherwise, it is not that hard to disconnect the cables from the handle inside the car. It all depends on why you are pulling the transaxle. -- Russ Wolfe '66 FB MT '71 FB AT '65 Bug (not running) russw@classicvw.org http://www.classicvw.org ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org