[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 30 Jun 2004 at 21:47, Hal Sullivan wrote: > At 06:54 AM 6/30/04, Jim Adney wrote: > >Right, but wasn't that a photo of the FRONT end of that tube? > > Yes it is. There's a similar hole/tube at the back of the rocker just > behind the edge of the fender where the harness breaks out. Okay, thanks. This sure must have been a chore to assemble even at the factory. > >If the rear was as you describe, then there must have been a side opening in > >that tube where the wires to the VR broke out. Is that right? > > Yup. Those wires (on this car) go *in* through the same hole under the rear > seat that later cars use to run the harness *out* under the fender. From that > hole back the routing seems to be the same (or at least very similar) Hmmm, do you mean that the tube ran intact from front to rear, but that the VR wires split off under the rear fender and came in under the seat via approximately the same route that later cars used for all the wires. Just asking, because this statement seems to be at odds with your agreement that the tube had a side port in it. -- Jim Adney jadney@vwtype3.org Madison, WI 53711-3054 USA ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org