[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 29 Feb 2004 at 12:23, Aaron Clow wrote: > I finally decided to take the CPU back out of Wilson & make sure it was > installed correctly, as that seemed to have been the source of a major > leak in the wagon. I am quite sure I did not notice the little metal > lips that go on the outside (correct?)... And I took some weather > sealant to adhere the rubber to the metal edges as well.. Yes, outside is OUT. I dont' use sealant, as that may may make it hard to get apart in the future. I haven't used this tester, but: > Faults were detected in: > > 1) Engine speed correction - full load enrichment Sounds like a throttle valve switch question. > 2) Start & warm-up enrichment Lack of the wire from the starter to the brain, possibly. What year is this? Were you set to the right year on the tester? The answers above depend somewhat on the year. -- ******************************* Jim Adney, jadney@vwtype3.org Madison, Wisconsin, USA ******************************* ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org