[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 21 Oct 2003 at 11:34, Aaron Clow wrote: > I believe that these connectors can go on either > injector connection, right? Right, even WITH the connector bodies, you can fit them in the injectors either way. > But how do I tell the "grouping" now that the boots are off? There is a number printed on each wire within 2" of the end. These are the wire numbers within the FI wiring harness. Assuming the PO didn't cut off more than necessary, you should be able to find some of those numbers (they are small.) Once you have the numbers, you can find which injector they go to by comparing to the FI wiring diagrams in the Bentley manual. If you can't find the numbers, you can always pull out the brain and remove the connector, then check for continuity back to each wire connector. The wire numbers are also on the brain end and correspond to the pin numbers in the brain connector. Is your mechanical advance working? -- ******************************* Jim Adney, jadney@vwtype3.org Madison, Wisconsin, USA ******************************* ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org