Re: [T3] Reworking cylindars

[Jim Adney <jadney@vwtype3.org>]

On 18 Mar 2003 at 19:11, phil cain wrote:

> Does anyone have any reason not to rework a set of P&L, putting new
> rings on(checking end gap), removing top ring land, honing liner to
> cross hatch.

I've done it lots of times. Use a ring to judge the cylinder wear at the top 
and bottom of the ring travel. Square the ring up in the bore with the piston 
and measure the ring gap.

-- 
*******************************
Jim Adney, jadney@vwtype3.org
Madison, Wisconsin, USA
*******************************

-------------------------------------------------------------------
List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org