[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
> I just checked the archives and couldn't find anything helpful. All I found was that people had the same problem as me. So, does anyone either know how to fix the electrical contact/movement part of a 67 ignition switch, or does anyone have a new/good used one? I wouldn't mind a good/used one because I could switch the keyed part from mine to it. > I have an NOS replacement but it's really expensive. Email me if you like. I have never replaced an ignition though, I have always been able to disassemble and repair them. If you remove the entire assembly and remove the side with the wires, you can figure out how it works. Assuming you have not lost any internal parts, clean it up and reassemble it, then make sure the little tabs are holding the wiring section in tightly, they come loose over time so the internals shift around and get scrambled. Before you reinstall the switch, test the positions either with a battery or a multimeter to make sure the on and start positions work as expected. I probably made it sound much simpler than it really is. I plan to take a bunch of photos next time I repair one. -- Everett Barnes everettb@thesamba.com http://www.thesamba.com ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ List info at http://www.vwtype3.org/list | mailto:gregm@vwtype3.org