Re: [T3] Removed original vinyl, and found surface rust, is this critical to remove??

[Ryan Langley <rlangley@mac.com>]

<x-flowed>I removed the sound deadening board in my fasty, which looked really 
good and was definitely replaced by a previous owner at some point, and 
found some pretty hefty surface rust setting in right under the glue. 
Then there were also places where you could see the por15 that had been 
applied looked fresh and clean. I guess you never can tell if you can't 
see under there.
Ryan
On Saturday, September 7, 2002, at 06:47 PM, Rob Carpenter wrote:

> Hello list,
>
> Im restoring my original '63 Notch, and so far through
> sanding etc, have found no rust. But I'm under the
> impression that the seals around the window were so
> bad that perhaps they leaked water, and or, also over
> the years spilled drinks in car etc, has caused some
> surface rust to appear.
>
> My question simply is this, I prefer not to remove the
> factory deadening material on the floor boards, and
> just carpet right over it, but my delima and question
> is, if I do this will this 'colored surface rust' get
> worse and spread, and I guess also I can't tell how
> bad it is unless I remove this material as apose to
> just peaking around the corners.
>
> Thanx again for all replys..
>
> __________________________________________________
> Do You Yahoo!?
> Yahoo! Finance - Get real-time stock quotes
> http://finance.yahoo.com
>
> ------------------------------------------------
> To unsubscribe, E-mail to: <type3-off@vwtype3.org>
> For more help, see http://vwtype3.org/list/


------------------------------------------------
To unsubscribe, E-mail to: <type3-off@vwtype3.org>
For more help, see http://vwtype3.org/list/
</x-flowed>