[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
<x-charset iso-8859-1>Baring that the underside of your car is not undercoated you may apply heat to the bottom of the pan. This will allow the original tar board to be removed and reinstalled. ----- Original Message ----- From: "Rob Carpenter" <brnagn7@yahoo.com> To: <type3@vwtype3.org> Sent: Saturday, September 07, 2002 6:47 PM Subject: [T3] Removed original vinyl, and found surface rust, is this critical to remove?? > Hello list, > > Im restoring my original '63 Notch, and so far through > sanding etc, have found no rust. But I'm under the > impression that the seals around the window were so > bad that perhaps they leaked water, and or, also over > the years spilled drinks in car etc, has caused some > surface rust to appear. > > My question simply is this, I prefer not to remove the > factory deadening material on the floor boards, and > just carpet right over it, but my delima and question > is, if I do this will this 'colored surface rust' get > worse and spread, and I guess also I can't tell how > bad it is unless I remove this material as apose to > just peaking around the corners. > > Thanx again for all replys.. > > __________________________________________________ > Do You Yahoo!? > Yahoo! Finance - Get real-time stock quotes > http://finance.yahoo.com > > ------------------------------------------------ > To unsubscribe, E-mail to: <type3-off@vwtype3.org> > For more help, see http://vwtype3.org/list/ ------------------------------------------------ To unsubscribe, E-mail to: <type3-off@vwtype3.org> For more help, see http://vwtype3.org/list/ </x-charset>