[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 14 May 2002, at 9:44, ApoplexY wrote: > I'm doing a pan replacement for my 63 notch... I have a 70 pan ready for > POR15 and a 68 rolling pan I'm trying to take apart to use the rear/tranny > and front ends. I think what you're trying to remove is called the rear subframe. There are 9 bolts holding this to the body/pan. Starting from the front there is one central bolt in the center point, with 4 more in a rectangular pattern around this. There are 2 more that screw up from below just to the rear of the torsion tubes just inboard of the spring plates. The last 2 screw down from above; look inside the trunk just inboard of the wheelwells, down in a covered opening in the trunk floor. - ******************************* Jim Adney, jadney@vwtype3.org Madison, Wisconsin, USA ******************************* ------------------------------------------------------------------- Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe