[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 2 Jul 2002, at 16:36, DAVID WALTERS wrote: > Same crank as before: I measured it at 70 mm, should-be, could-be a 69 mm? (I > thought there were no 70 mm cranks, is this right?) OE stroke is 69mm. No doubt that's what you have. > AAR, deck height measured on 1 cylinder (bolted down at TDC) at .055" > (.030+.025+ wouldn't take a .001" feeler gauge) along with a 56 cc(is that > right?) on a stock 041 head gives a final of 1585 cc's (@69 X 85.5mm's). I get 7.1:1, which should not be too bad. > 1. Deck height should be optimal at .055" to.065", is > this right? This motor had no shims/ no spacers on the > barrels when I tore it down, I hadn't planned on > putting them on unless I had a cylinder out of spec. OE engines never had shims to my knowledge. I'll let someone else work on the hard stuff you asked. - ******************************* Jim Adney, jadney@vwtype3.org Madison, Wisconsin, USA ******************************* ------------------------------------------------ To unsubscribe, E-mail to: <type3-off@vwtype3.org> For more help, see http://vwtype3.org/list/