[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
<x-charset ISO-8859-1>Ok, I spent the entire weekend adjusting valves, setting points, cleaning plugs,etc. Over and over again. The problem I cannot get around is that it appears to be running on 1 cylinder. I can pull off the wires of cylinder # 1,3,4 all at the same time and it does not cause a change in the idle. I pull #2 off and it stalls (yes with 1,3,and 4 connected). I have spark at all 4 plugs, and good spray from all 4 injectors. I do not have a timing light,but spent hours trying to time it by ear, but no matter where I turned the dizzy, it did not cause any change in these cylinders. (I will be getting a light this weekend)Where do I go from here? I adjusted my valves to .006, and noticed on the archives that you guys are setting them at .006/.004,could this be it? I will be doing a compression check next weekend. Fuel pressure/voltage/head temp sensor are all ok. Thanks, Robb ------------------------------------------------------------------- Search old messages on the Web! Visit http://www.vwtype3.org/list/ </x-charset>