Re: [T3] Spark Plug Leads

["Mark Seaton" <mark.seaton2@ntlworld.com>]

<x-charset iso-8859-1>Russ you were right- I measured them today and they have 1K resistance. Will
this cause me a problem if I use them with resistor plug caps?- I kind of
doubt it would have much effect on 20 KV. I still need to find another one
though and if they were some fancy optional accessory I think I might wait a
long time!

Thanks for the tip

Mark Seaton
Orange 72/73 Carbed Fastback, London


----- Original Message -----
From: "Russ Wolfe" <russella@prairieinet.net>
To: <type3@vwtype3.org>
Sent: Monday, January 07, 2002 7:50 PM
Subject: Re: [T3] Spark Plug Leads


> On Monday 07 January 2002 10:52, Jim Adney wrote:
>
> >
> > I've never seen Beru right angle dist ends, but they may have been
> > used at some time. All mine are Bosch. The right angle ends are
> > really important to keep the dist wires from wearing against the
> > engine cover and destroying the insulation as well as wearing thru
> > the wires themselves. Those ends are no longer available at any
> > price and were pricey when still available. I have good used Bosch
> > ones. They are excellent quality and last forever.
> >
> I think, that if checked with an ohm meter, you will find that the Beru
ends,
> are resistance. They were part of a radio suppression kit.
>
> --
> Russ Wolfe
> '71 Fastback AT
> '66 Fastback MT (IT RUNS)
> russw@classicvw.org
> http://www.classicvw.org
>
> -------------------------------------------------------------------
> Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe
>

</x-charset>