Re: [T3] Disc Brake Seal & Ball Joint Boot Questions

[Parker-Durost <ginpete@xprt.net>]

One outer notch is nearly 2 inches, and one inner notch is a little
more than that.  To do one inch you'll need to do a combination of
inner and outer.  This is a little risky not to loose track, make sure
you mark both ends of the bar.  I believe Haynes lists the number of
notches that will allow you to do the math.

Peter Parker
'66 Square; Phillip
Portland, OR

>While I have the front end in pieces I was thinking of lowering the
front
end slightly to match the sagging back end. I want to go down about 1
inch
or so. How hard is it to get everything lined up if I do decide to go
ahead
and lower it, and how many splines would achieve a 1 inch drop?


------------------------------------------------
To unsubscribe, E-mail to: <type3-off@vwtype3.org>
For more help, see http://vwtype3.org/list/