[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 10 Aug 2002, at 22:45, Parker-Durost wrote: > The question I have is where to put the paper gasket (kit comes with two) in > relation to the backing plate and the large bearing O.D. o-ring. If I > remember correctly, when I assembled it, I used one gasket on the bearing > cover, with the o-ring up against the bearing housing. But because the > gasket I.D. matches the bearing O.D., the gasket gets partly folded into the > bearing cover chamfer (intended for the o-ring). It sounds like I put the > o-ring on the wrong side of the gasket, but at the time this didn't seem > right. I think they came from the factory the way you did it, with the paper gasket pressed backwards into that triangular cavity that seems like it was destined for an O-ring. I have done them the other way, with the O-ring in the cavity and that also seemed to work just fine. Did you install the other paper gasket on the inside face of the brake backing plate? Did you install a new small O-ring? Is your new oil seal installed with the lip facing in? (It should face in.) - ******************************* Jim Adney, jadney@vwtype3.org Madison, Wisconsin, USA ******************************* ------------------------------------------------ To unsubscribe, E-mail to: <type3-off@vwtype3.org> For more help, see http://vwtype3.org/list/