[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 10 Apr 2002, at 19:05, Drake wrote: > The only number I can see on the pressure sensor is 242 103 10250 The > sticker I believe has the company name Python, it also says remanufactured. It > looks like it has been replaced quite recently. There is no black plastic cover > that I can see. The rear end of it looks like there is a reddish colored sealant > of some type in the center, possibly epoxy. Python is an independent rebuilder. I don't know what their numbers mean, so we still don't know what this is. Perhaps you could call them or check their web site. > I checked through the book of receipts I have but unfortunately could not > locate one for the pressure sensor. I did however find out that the > injectors, and ECU were replaced in 95. Fuel pressure regulator, both front > brake calipers, and clutch cable replaced in 01. Also found out that a couple of > the previous PO's took the thing in to get oil changes, and just about every oil > weight known to man had been put in the previous engine at one time or another. If we can assume that the people who did all this work were reasonably competent, then these parts may all be 73 parts. > I gave the dist number in another email but its 311 905 205 A-B or 0 231 136 > 008, with a #265 vac arm. Both numbers are on the dist, first one under the > latter. This is a 70 dist, but I suggest that you go ahead and time it like a 73 since it appears that all the FI parts may be 73. That is at 5 BTDC. This should improve things. - ******************************* Jim Adney, jadney@vwtype3.org Madison, Wisconsin, USA ******************************* ------------------------------------------------------------------- Unsubscribe? mailto:type3-request@vwtype3.org, Subject: unsubscribe