[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: [T3] RE: Just reinstalled engine questions
<x-charset iso-8859-1>>-> This was lined up only for cyl #1 only right? You rotated the engine
>before doing the next cylinder right?
>D e r e k F l e n n i k e n
Sorry, Yes! I lined that up for No. 1, then went 180°CW and did 2, 180°CW
and 3, etc. I will go back and double check later, but just wondered if
this sounded familiar and might have been something stupid I did that rung a
bell.
--> Sounds good. I can never remember which way you turn the engine (and I
suppose you could go either way), I always double-check that the dizzy rotor
is pointing to the spark plug wire for the cylinder I'm about to adjust and
then that the fan wheel is at 0 or at 180. Did you set the gap to .006 or
.004? I have 3 manuals and I remember that one said to use .004 (can't
recall which one), but the proper gap is .006. I always double-check the
gap after I lock it down with the nut. Sometimes tightening that nut causes
the valve to adjust (or mis-adjust). Just a little game you get to play
with your valves. ;-)
D e r e k F l e n n i k e n
1971 Squareback
San Francisco, CA
derek@enth.net
-------------------------------------------------------------------
List info at http://www.vwtype3.org/list or mailto:help@vwtype3.org
</x-charset>