[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [T3] Original inner wing underseal
<x-flowed>>From: "craig.webb" <craig.webb@pgen.net>
Anyone got any pointers on the best way to remove the factory underseal
I've tried heat, flame, wire brush and thinners with no joy. Wire brush
has
the best chance, but its really taking a long, long time.
Hi Craig
When I used to work in a body shop some years ago, we used to use a torch to
soften the underseal just enough to use a scraper which would get about 95%
of it. Then followed that with lacquer thinner, acetone, or some other type
of solvent cleaner. This worked very well and was preferred over a wire
wheel or brush. The wire wheel made a bigger mess and the wire brush seemed
to gum up. However, remember there was no real enjoyment here except when
done. Very cost effective too.
It been awhile since then, and perhaps there are some good solvents that
will accomplish the same thing with less hassle, which I hope there is. If
you go with a solvent, make sure there is plenty ventillation, wearing a
good mask is always advisable, and good gloves to keep the solvents from
getting into the pores of the skin. This may sound scary, but with the
proper care taken, we got the job done fast and results were very clean.
Bruce
_________________________________________________________________
MSN Photos is the easiest way to share and print your photos:
http://photos.msn.com/support/worldwide.aspx
-------------------------------------------------------------------
Search old messages on the Web! Visit http://www.vwtype3.org/list/
</x-flowed>