[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
<x-charset ISO-8859-1>Jim, maybe you should explain what you do or what the parts (and numbers) are you use to circumvent such clearance issues. Toby Erkson air_cooled_nut@pobox.com '72 VW Squareback 1.6L bored and stroked to 2.0L, Berg five-speed '95 VW Jetta III GL 2.0L, P-Chip, Jamex suspension, 2.25" MagnaFlow exhaust, etc. Portland, Oregon, http://www.icbm.org/ >-----Original Message----- >I installed the Berg kit recently. I had to clearance >the fan housing AND the NPT fitting that threads into >the case. The fan housing had to be clearanced down to >a very thin sheet of metal and then peened back a bit >with a hammer to clear the fitting and hose. It was >enough to poke a small hole that I filled in with a >generous amount of black silicone. The flat surface of >the case was even machined down by Rimco, per Gene >Berg instructions and there was still not enough room. >... ------------------------------------------------------------------- Unsubscribe? mailto:type3-request@vwtype3.org, Subject: unsubscribe </x-charset>