[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
<x-flowed iso-8859-1> Hello, Searched high and low in the history after a member of this list directed me to this list. Couldn't find all the answer I wanted to know about full flow on a T3. Here are some questions which are unaswered: 1. Is extra flattening of the machined surfaces OK. Both oilfilterbracket and flowcover. 2. Use Loctite 648 fixation OR Prime lok 245 blue threadlocker OR something else for the NPT fittings? 3. Mayor problem: I ordered wachers to adapt a 8 mm cover to 6 mm studs. I thought these were thick wachers (8 mm outside) with an out of center 6 mm hole. I got some regular washers. Use these OR machine some OR fill the hole with RTV silicone? 4. What to use on the gasket between cover and pump. Oil OR sealer? 5. I milled a bushing and pressed this in the outlet of the pump. Forgot to use Loctite fixation! Used a "pin" through the housing and bushing to keep it in place. Leaktested this with petrolium. Didn't leak. Will it be leakfree under high-oil pressure? Or will the oil find the easiest way, lower pressure, against the outlet? 6. I milled down the surface for the inlet at the case. Drilled it and tapped with NPT. I was wondering how deep the fitting has to be? Does it have to threated beyond the original oilgallery (the one from the outlet of the pump to where you make you inlet) or doesn't it matter because this gallery is plugged anyway (at the pump) OR don't go that far because there is a splitgallery to oil the front bearing? I read in the history some of the members have gone through the installating of the GB set-up. Maybe they still have the full instructions which were included? Can someone answer on the list or mail the instructions? Any comment/input appreciated. Van der Jeught Bert, BELGIUM _________________________________________________________________ Meld je aan bij de grootste e-mailservice wereldwijd met MSN Hotmail: http://www.hotmail.com/nl ------------------------------------------------------------------- Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe </x-flowed>