[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On Friday 07 September 2001 07:49, Thorkhild wrote: > . I beleive you don't actually have to take off the pedal assembly to > change teh clutch cable. There is an access panel in the middle of the > frame head just left the master cylinder. Its held on by 3 or 4 10mm bolts. > once off you can reach inside and attach your cable to the hook on your > pedal assembley. You might have to loosen the pedal adjust stop. I did mine > that way, BUT my body was off at the time so getting my arm through there > was very easy. It was alot easier this puting the cable back on , from when > i did it last when i removed my pedal assembly to replace a broken brake > line. > That is more work than it is worth. Factory proceedure is to pull the pedal assembly out. Shop flat rate time to replace the clutch cable was only .75 hr. Most VW shop mechanics could do it in less than .5 hr's Get the clip off the pin, disconnect the throttle cable from the roller arm, remove the 2 bolts, unhook the spring from the pin, and bingo, the pedal assembly is out. -- Russ Wolfe russw@classicvw.org http://www.classicvw.org ------------------------------------------------------------------- Unsubscribe? mailto:type3-request@vwtype3.org, Subject: unsubscribe