[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On Wed, 17 Oct 2001 19:41:51 -0600, Jim Adney wrote:
>On 17 Oct 2001, at 16:19, Mark Healey wrote:
>
>> I got a scan of a spec sheet/drawing from Amp.
>>
>> http://www.healeyonline.com/~marksvw/c925558.jpg
>
>These are close, and they MIGHT even work, but they are not ours.
>I see 2 differences: The contact tips of these are rolled over to give
>a wider contact, while on ours the contact is only as wide as the
>sheet the contacts were punched from.
Actually if you take it out and look at it they are rolled as well, at
least on the 71, and 72 harnesses I have.
>And the tips on these are
>gold plated, while ours are not.
>From what I've figured out so far the two rightmost columns are part
numbers. The part after the dash is is a subscript. "Werkstoff" is
what it is made of. "Oberfl„che" is what they are plated with.
"Drahtbereich", "Isolations í", "Band-Stand", "Band MQC" and
"Einzelausf" Have me stumped.
So the table is:
0,5...1,0 mm^2 1,8---2,8 Brass Unplated 925558-8 925558-6
0,5...1,0 mm^2 1,8---2,8 Brass Zinc 925558-7 925558-5
0,5...1,0 mm^2 1,8---2,8 Bronze Tips plated with 925558-4 925558-4
.0008mm of gold
0,5...1,0 mm^2 1,8---2,8 Bronze Tips plated with 925558-3 925558-3
.0004mm of gold
0,5...1,0 mm^2 1,8---2,8 Bronze Zinc 925558-6 925558-2 925558-2
0,5...1,0 mm^2 1,8---2,8 Bronze Unplated 925558-5 925558-1 925558-1
? ? Material Plating ? ? ?
Mark Healey
71 FI auto square
71 FI manual square
marksvw@healeyonline.com
-------------------------------------------------------------------
Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe