Re: [T3] loose shifting

["Jim Adney" <jadney@vwtype3.org>]

On 28 May 2001, at 21:54, Ginger D.&Peter P. wrote:

>     When I did this project, I also had a cracked shift bushing
> "hanger".  This had to have the spot welds drilled out and an new 
> hanger bolted in. I didn't discover the new hanger was defective
> until tightening the final bolt, and I had to do it all over again! 

Where was it cracked? Could you tell what caused it to break? I 
never heard of this happening, so you must be VERY special.  ;-)


-
Jim Adney
jadney@vwtype3.org
Madison, WI 53711-3054
USA

-------------------------------------------------------------------
List info at http://www.vwtype3.org/list or mailto:help@vwtype3.org