Re: [T3] POR 15 for type threes

["Ginger D.&Peter P." <gingerd@teleport.com>]

POR-15 is awesome.  I used it on the floors and rear seat divider/support.
Starting condition was crusty rust with pin holes, surface rust, and no rust
with nice factory paint.  The instructions suggested multiple coats, but it
covered so well and looked so good I didn't bother.  I used about 1/2 quart.  I
used a cheap 2" China brush, and put it on thick.  For the first 5 minutes it
looked crappy, with huge bristle texture.  But then the beauty of this stuff is
it settled in and layed down.  It filled all the nooks and crannys, even the pin
holes (put tape on the outside first).  I used gloss black, and can still see it
shining on the rear heater outlets.
    There's a finished floor photo in the Phillip section of
http://www.teleport.com/~gingerd

Peter Parker
'66 Square; Phillip
Portland, OR

-------------------------------------------------------------------
Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe