[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [New Search]
On 17 Jun 2001, at 15:29, Joe Plowick III wrote: > You will also have to modify the fan shroud as well. When I was > fitting things, it appeared I wouldn't have to. But now that > everything is going together, I need to cut a small hole in the fan > shroud to allow the mounting stud and part of the line fittings to > protrude through. I should be able to cover up the holes with JB weld > or something. If I had been using a smaller oil pump (ie. 21mm vs. my > 26mm) I probably wouldn't need to do this. I manage to fit a 26mm pump in without any modifications at all to the fan housing. It's a matter of getting the right street elbows. If you mean the oil pump studs, you can set then at whatever depth you need so they don't protrude out past the nut. - ******************************* Jim Adney, jadney@vwtype3.org Madison, Wisconsin, USA ******************************* ------------------------------------------------------------------- Too much? Digest! mailto:type3-d-request@vwtype3.org Subj=subscribe